Stripped Slide for Glock G17
- Heat Treated 416 Stainless Steel
- Fits Glock Gen 1-3
- Fits Polymer80 PF940V2
- Front & Rear Sight Cuts
- Rear Serrations
- RMR Cut
- Side and Top Porting
- Pre-installed Channel Linear
- Made in the USA
- OEM Sights NOT INCLUDED
- Does not come with RMR Plate Cover
MDX Arms does not sell firearms. This is not a firearm and will ship directly to you without FFL needed
We do not ship 80% to New Jersey and WA State
Please refer to your state and federal laws about 80% kits. It's your responsibility to know your own laws.
We're not responsible for any improper milling, installation of parts, damage or any injury that might occur. Make sure to use proper safety equipment during your build
“GLOCK” is a federally registered trademark of Glock, Inc. and is one of many trademarks owned by Glock, Inc. or Glock Ges.m.b.H. MDX Arms
is not affiliated with nor endorsed by Glock, Inc. or Glock Ges.m.b.H.
3 Reviews Hide Reviews Show Reviews
Easily a $400-$500 slide for cheaper! Runs great, looks awesome and the cerakote is sprayed so well!
The slide went together easy enough,and has a really nice finish. But it does not have the protruding posts in the RMR cut as pictured, just threaded holes. Also when I went to install my Ameriglo suppressor height sights I could push the rear sight through with my thumb. This could have been the sight. I have no way to measure the dove tail.
I ordered this slide for my p80 build over Black Friday. Once it finally showed up. I was pretty impressed with the quality of it. The cerekote finish on it came out fantastic!